Becker C16, Руководство по сборке и эксплуатации

Страница: 11 / 24

Readying the tubular drive for programming with the radio switch
Switch the radio switch to the inside position. If the radio switch is already in this posi-
tion, switch it to the outside and back to the inside position.
► The tubular drive is ready to programme for 3 minutes
Programming the master transmitter
3s
Press the programming button for 3 seconds when it is ready to programme.
▻ The tubular drive acknowledges.
► The programming process is now complete.
If a transmitter is already programmed on the receiver, press the programming button for
10 seconds.
Checking that the running direction is correct
The direction of rotation can only be changed if no limit position has been set.
There are several ways to change the direction of rotation:
•
Changing direction of rotation via the direction switch
•
Changing direction of rotation via master transmitter
Changing direction of rotation via the direction switch
Press the or button.
▻ The shading solution runs in the desired direction
► The running direction is OK.
If the shading solution runs in the wrong direction, the running direction must be changed. Proceed as follows:
Switch the direction switch (1) to the opposite position.
▻
The running direction will now have changed.
►
Check the running direction again.
11 - en