MX-240
Quick Install Guide
www.bectechnologies.net
www.bectechnologies.net
M
2
M
K
IT CONTAINS: DIN Rail Clip and Six (6) Clip Mounting Screws
T
he DIN Rail mounting kit is designed to securely attach and clip the MX-240 onto a TS35 or standard 35mm top hat
(EN 500022/BS 5584) DIN rail in the horizontal position.
T
wo (2) mounting locations to mount the DIN rail clip on the surface of MX-240, back or rear side.
Please follow the steps to complete DIN rail mounting installation.
3301 Matrix Drive Ste 200
Richardson, TX 75082 USA
TEL : +1-972-422-0877
FAX : +1-972-422-0886
E-mail : [email protected]
FCC Caution:
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions:
(1) this devise may not cause harmful interfer-
ence, and
(2) this device must accept any interference
DIN RAIL MOUNTING KIT INSTALLATION
ATTACHING TO A DIN RAIL
REMOVING FROM A DIN RAIL
1. MX-240
2. Mounting Bracket 3. Mounting Screws
I
Gb
ETH
2
SERIAL
I
1
Bottom
2
Top
3
4
III
C
lip and secure the MX-240 onto a DIN rail.
1.
Hook the top of the clip onto the top edge of the DIN
rail. Make sure the clip is firmly against the rail.
2.
Push down the bottom of the MX-240 to snap it onto
the lower edge of the DIN rail.
3.
The MX-240 is now mounted on the DIN rail.
v1.0
A
ttach and fasten the DIN rail clip (known as clip) to the
back or rear side of the MX-240 using two (2) clip
mounting screws included in this mounting kit.
R
emove MX-240 from a DIN rail.
1-2.
Push down the MX-240 to free the bottom of the
clip from the DIN rail.
3-4.
Unhook the top of the clip and pull the MX-240
away from the DIN rail.
II
I
nstall clip in either vertical or horizontal position.
ANT 1
ANT 0
(MAIN)
RESET
VCC
GND
ANT 3
ANT 2
MINI USB
1/W
AN
2
Gb ETH
DIN Rail
1
Top
Bottom
2
MINI USB
1/W
AN
2
Gb ETH
3
MINI USB
1/W
AN
2
Gb ETH
MINI USB
1/W
AN
2
Gb ETH
3
MINI USB
1/W
AN
2
Gb ETH
MINI USB
1/W
AN
2
Gb ETH
MINI USB
1/W
AN
2
Gb ETH
MINI USB
1/W
AN
2
Gb ETH
MINI USB
1/W
AN
2
Gb ETH
MINI USB
1/W
AN
2
Gb ETH
3
1
2
3
ANT 3
ANT 2
ANT 1
ANT 0
(MAIN
)
RESET
VCC
GND
MX-240 INSTALLED WITH A DIN RAIL