3
SAFETY INSTRUCTIONS
WARNING!
Before carrying out any operations with the unit, carefully read this instruction manual and keep it with care for future reference. It
contains important information about the installation, usage and maintenance of the unit.
•
Unpack and check carefully that there is no transportation damage before using the unit
•
Please read these instructions carefully and follow the instructions.
•
Observe all safety warnings. Never remove safety warnings or other information from the equipment.
•
Be sure that no ventilation slots are blocked; otherwise the unit will overheated.
CAUTION:
Before connecting the equipment to the power outlet, first verify that the mains voltage and frequency match the values specified on
the equipment. If the equipment has a voltage selection switch, connect the equipment to the power outlet only if the equipment values and the
mains power values match. If the included power cord or power adapter does not fit in your wall outlet, contact your electrician.
•
After connecting the unit, check all cables in order to prevent damage or accidents, e.g., due to tripping hazards.
•
Make sure that the power cord is never crimped or damaged. Check the device and the power cord from time to time.
•
Always disconnect power from the mains, when device is not used or before cleaning! Only handle the power cord by the plug. Never pull out
the plug by tugging the power cord.
•
Unplug the power cord and power adapter from the power outlet if there is a risk of a lightning strike or before extended periods of disuse.
•
Do not switch the unit on and off in short intervals.
•
Do not connect the unit to a dimmerpack.
•
Install the unit in a well ventilated place.
•
Never place any material over the lens.
•
Always allow free air space of at least 50 cm around the unit for ventilation.
•
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the fixture.
•
For mounting height >100 cm, always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the correct fixation points only.
The safety-rope must never be fixed at the transport handles!
•
Never look directly at the light beam. Please note that fast changes in lighting, e. g. flashing light, may trigger epileptic seizures in
photosensitive persons or persons with epilepsy.
•
This unit is not designed for permanent operation. Consistent operation breaks will ensure that the device will serve you for a long time
without defects.
CAUTION:
If the power cord of the device is equipped with an earthing contact, then it must be connected to an outlet with a protective ground.
Never deactivate the protective ground of a power cord.
•
Make sure that the unit is not exposed to extreme heat, moisture or dust.
•
Clean the unit using a dry cloth.
•
Do not touch the fixture bare-handed during its operation (housing becomes very hot). Allow the fixture to cool for at least 5 minutes before
handling.
•
This unit is designed exclusively for indoor use, do not use this equipment in the immediate vicinity of fluid (does not apply to special outdoor
equipment - in this case, observe the special instructions noted below). Do not expose this unit to flammable materials, fluids or gases.
•
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising
condensation water might damage your unit. Leave the unit switched off until it has reached room temperature.
•
Never attempt to bypass the thermostatic switch or fuses.
•
Do not dismantle or modify the unit.
•
For replacement use fuses/bulb of same type and rating only.
•
Repairs, servicing and electric connection must be carried out by a qualified technician.
•
The ambient temperature must always be between -5° C and +45° C.
•
If this unit is operated in any other way, than the one described in this manual, the product may suffer damages and the warranty becomes
void.
•
Plastic bags must be kept out of reach of children.
•
Unit must be installed out of the reach of children. Never leave the unit running unattended.
This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be
handed over to the applicable collection point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural
resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal
service or the shop where you purchased the product.
Содержание 150.384 V1.2
Страница 1: ...Fuze 75B Beam 150 384 V1 2 ...
Страница 38: ......
