Beamz Pro 10B01F43, Руководство пользователя

Страница: 5 / 48

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product
must be returned to the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
The label on the backside of the unit indicates the mains voltage to which it must be connected. Check that the mains voltage corresponds to this.
Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must also be connected directly to the mains voltage
and no dimmer or adjustable power supply may be used.
The unit has a powerconnector output on board. Depending on the local conditions several units can be linked by powerconnector in- and output.
Connect a maximum of four (when using 230V/16A) units in a row. Use an approved three-core cable with a cross-section of at least 1.5 mm². The
installation instructions of the manufacturer and the colour coding of the cable must be observed. Do not turn off the unit by turning the
powerconnector but use the power on/off switch or schuko!
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
The unit may be set up on a stable and even surface. By means of the fixing facilities of the baseplate, the unit can also be mounted upside down to
a truss, see below picture. For fixing, certified clamps with correct save working load are required. According to the figure, the quick lock bolts of
the omega brackets are placed into the openings provided in the base plate and turned clockwise until they lock (to the stop). The mounting place
must be of sufficient stability and be able to support a weight of 10 times of the unit’s weight. Secure the unit with a safety cable so that it cannot
fall down.
When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let
the installation checked out by an authorized dealer !