Beamreach networks BeamPlex BRU-100, Руководство по установке и обслуживанию

Страница: 42 / 56

Ch. 3 Installation Tool Remote Unit Installation
Other Technical Features Service Utilities
36
Pre-Production
1106333-01
Revision 3
Other Technical Features
This section presents two additional features of the BRU-150 that you will
use.
Default Configuration Button
There is a default configuration button located behind the front panel of
the BRU-150 transceiver, as shown in
Figure 1-2 on page 6.
Actuating this button causes the following actions:
♦
Cycles power to the transceiver
♦
Sets the IP address to the default 192.168.1.1
♦
Sets the subnet mask to the default 255.255.255.0
♦
Sets the base station offset code to the default -1
Insert a paper clip, or similar object, through the hole in the front panel to
actuate the button.
Shortcut Menu
When either the status monitor or installation tool applications are
opened, an icon appears in the Windows system tray of the service
computer. When you close the application window, the system tray icon still
remains and the application runs in the background.
Right-click the system tray icon to access this shortcut menu. Note that the
menu commands differ depending on which of the service utilities are
open. When the status monitor is open, the
Start BRU-150 Installation
command is not present.
The commands on this menu are
described below.