Beamreach networks BeamPlex BRU-100, Руководство по установке и обслуживанию

Страница: 37 / 56

Remote Unit Installation Ch. 3 Installation Tool
Service Utilities Installation Tool Operation
1106333-01
Pre-Production
31
Revision 3
Step 2
If you do not obtain an adequate signal from
Base1
, repeat this process with
Base2
and then with
Base3
as needed.
Step 3
If no antenna location results in clearly superior signal, then review the
signal strength detail reports that were saved, as described above. The next
section provides guidance in interpreting the data in those reports.
Signal Strength Details
Look for the following three data types, listed here in order of importance:
♦ RSL
(received signal level)
High value preferred. Note that these are negative numbers.
♦
SNR
(signal/noise ratio)
High value preferred.
♦
Est. Path Loss
Low value preferred.