BeaconMedaes TotalAlert 2, Инструкции по установке, эксплуатации и обслуживанию

Страница: 120 / 144

118
6-847718-00 Rev. B00
Testing
• All LEDs illuminate for 1 s and module
returns to monitoring mode.
Press and hold front panel TEST button for
5 s to initiate following sequence:
• Audible alarm sounds for 1 s.
• All red and green LEDs flash for 5 s.
• Software revision is displayed as
follows:
- Expressed as a three digit number
(e.g. 1.0.2).
- Each digit of number is displayed
separately for 2 s and separated
from the next digit by a brief flashing
of all indicators.
- Each number is displayed in a
binary code where each multi-signal
module LED has a binary value
(Figure 110.).
- Example: Software revision 1.0.2
would be displayed as follows:
• First digit is determined by 2 s
illumination of top left indicator
(bit 0 = number 1).
• All LEDs quickly flash.
• Second digit is determined to be
0 because no indicators are
illuminated for 2 s.
• All LEDs quickly flash.
• Third digit of is determined by 2
s illumination of 2nd red indicator
(Bit 1 = number 2).
• After all three digits of software revision
have been displayed, all LEDs
illuminate for 1 s before displaying the
module’s network address.
• Network address is displayed for 2 s in
a binary code where each multi-signal
module LED has a binary value
(Figure 110.).
Multi-Signal Module
SIGNAL 1
SIGNAL 2
SIGNAL 3
SIGNAL 4
SIGNAL 5
Bit 4 (16) Bit 0 (1)
Bit 1 (2)
Bit 2 (4)
Bit 3 (8)
Bit 5 (32)
Bit 6 (64)
Bit 7 (128)
Figure 110: Binary data represented by LEDs
Red LEDs Green LEDs