1/2
EAS RF
USER’S GUIDE
EASY ACCESS SYSTEM BASED ON RADIO FREQUENCY
EAS RF RECEIVER
EAS RF KEY FOBS
EAS RF TRANSMITTER
FOR PUSH PLATES
To open the receiver, expand the two
sides of the box and lift up the cover.
In its standard position, the antenna has a
maximum range of 10 m (open field).
To obtain a range of max 25 m, you can change the
position of the antenna as shown above.
LED Receiver
YELLOW
The
record LED
flashes when the system receives information coming from any key fob/transmitter
(recorded or not). During a ‘record’ sequence, the LED switches on until the system receives the data
coming from the new key fob/transmitter.
RED
The
output
LED
switches on when the output is activated.
LED
Key Fob/Transmitter
RED
The
check LED
switches on when the key fob/transmitter sends data to the EAS receiver.
Dip Switch Settings
1
2
ON
▲
Output
Toggle mode
Hold time
10s
OFF
▼
Output
Impulse mode
Hold time
0.5s
Toggle mode
When you press the button of the key fob/transmitter, the output is
activated until you press the same button again.
Impulse mode
When you press the button of the key fob/transmitter, the output is
activated during 0.5 or 10 s (depending on dip switch 2).
Add one Key Fob/ Transmitter
1.
Press the
record button
on the EAS
receiver
once
. The yellow LED will switch on.
2.
Press the
button
of the new EAS
key fob/
transmitter twice
.
When the LED stops flashing the key fob/transmitter is recorded in the system.
Remove all
Key Fobs/ Transmitters
1.
Press the
record button
on the EAS
receiver until
the
yellow
LED switches off
(about 8 s).
2.
The memory of the receiver is cleared now and you can re-activate your EAS key
fob(s)/transmitter(s) by using the above mentioned procedure.
1
Available from this range
(sold seperately)
2
General information
Large
Button
Small
Button
