BCS DEVILLE II Скачать руководство пользователя

Страница: 10 / 12

I inflated my fork and it is really hard, what can I do?
Did you change your fork’s settings? Check that your settings are close to our recommended base settings
given in the setup section of your product’s user manual.

If the issue is still present, you may have some internal pressure from the production process. You can
eliminate this pressure by slipping a thin zip-tie between your fork dust seals and your stanchion until you hear
the sound of air escaping. Then set again your fork air pressure.

If your fork is still hard, please contact our customer service on

[email protected]

I have about 5mm of travel unused when I ride normally.
Our forks are designed to be very progressive at the end of travel to give you a bottomless feeling. This means
that those last couple millimeters of travel might only be used on the biggest hits or when you case a landing.
You can think of them as insurance to get you out of the trickiest situations.

If more than about 5% of your travel remain unused, try lowering your air pressure by 5PSI and check your
compression settings. If your compression settings are much harder than our recommended values, try
bringing them closer to the base settings in your product’s user manual.

I have grease/oil coming out of my brand new fork seals.
This is not unusual at the beginning of the life of a fork. Clean off the stanchions and the seals and it will
disappear after a few rides.

My fork has been sitting for a couple of weeks and some oil came out of the seal when I rode it the first
time.
BOS seals can let out a little bit of oil when they have been sitting and dried out. Wipe off any oil, and none
more will come out when the seal is lubricated again.

I have grease/oil coming out of my well-ridden fork seals.
It’s time for a service! Contact your nearest BOS authorized service center for a full service.

But I haven’t reached your recommended service interval yet
Our recommended service intervals cannot cover 100% of customer’s usage cases. Use in wet/muddy
conditions; a prolonged storage out in the sunlight; frequent use; or improper care can all cause a quicker
wear out of the seals.

Where can I find my serial number?
The serial number is engraved under the steer tube; it’s composed of 7 digits.

How can I adjust my FCV?
The FCV is a very precise, internal system who is preset in our factory.

For any other questions, please feel free to contact us by e-mail at

[email protected]