GSC3219TA
Owner’s Manual
16
DANGER:
To prevent fire or explosion hazard when testing for a leak:
1. Always perform the “leak test“ before lighting the grill and each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until all leaks have been stopped. If you are unable to stop a leak, disconnect the propane supply, call for gas
appliance service or your local propane gas supplier.
Checking for Leaks
1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2. Make sure control knobs are in the “OFF” position.
3. Spray some solution on the tank valve up to the regulator connection.
(See diagram to right.)
4. Inspect the solution at the connections for bubbles. If no bubbles appear, the connection
is secure.
5. If bubbles appear, you have a leak. Go to step 6.
6. Disconnect the regulator from the tank and reconnect. Make sure the connection is tight and secured.
7. Retest with solution.
8. If you continue to see bubbles, replace the cylinder.
Lighting Your Grill
DANGER:
Failure to open lid while igniting the grill’s burners or not waiting five minutes to allow gas to clear if the grill does not light, may
result in an explosion, which could cause serious bodily injury or death.
WARNING:
Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily injury.
Lighting Main Burner
1. Open
lid while lighting burners.
WARNING:
Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no
obstructions of airflow to the gas unit. Spiders and insects can nest and clog the burner/venturi tube at the orifice. A
clogged burner tube can lead to a fire beneath the appliance.
2. All valves must be in the “OFF” position.
3. Open
cylinder
valve.
4. Ignite only the burners you wish to use, using the same method for each:
Push and turn desired burner valve knob and rotate slowly about 1/4 counterclockwise
until a click is heard. (See diagram to right).The burner should be lit.
If the burner does not
light, repeat 2 or 3 more times.
If ignition does NOT occur in 5 seconds turn the burner controls to
OFF, wait 5 minutes, and repeat the lighting procedure.
After burner is lit, repeat the procedure
with any other burner desired.
5. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1. Insert a match into the end of lighting stick locked in the drawer. Light the match.
2. Once lit, put the lighting stick through the cooking grid and place the flame next to
the burner ports found along the sides of the desired burner (See diagram to right.)
3. Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’ position. The burner
should light immediately. If more than one burner is desired, repeat the procedure 2-3
until all desired burners are lit.
4. Adjust burners to the desired cooking temperature.
