Programming manual SCU-series
HB-37500-820-10-12F-EN SCU Programming manual
Page 87 of 252
Status: 19.03.2021
2. The encoder settings for the respective / selected axles must be set as follows:
•
By clicking on the desired axis symbol, the properties can be shown in the window
“
Properties
”
.
•
The properties of the selected axis can be changed via the window
“Properties”
(bottom right).
In doing so, the settings must be set according to the encoder’s data sheet.
Examples of settings: type, scaling, direction, transmission, position limits and
speed limits, switch-off thresholds, acceleration, etc.
3. After all encoder parameters and all network parameters have been set, the
Slave-unit SDC is integrated.
Klick
Figure 67 SDC axes
Figure 68 Properties of the SDU axle(s)