Page
9
Serial
Setup
Detail Operations and Configurations
MAIN
MENU
Menu 1: Main Manu
Connect the
9FRJ45PC-4
adapter to the user’s computer
Connect the MODULE EIA-232 port to the adapter via the
RJ08X007
rolled flat ribbon cable.
Use terminal emulation software to access the unit,
9600 bps, 8 data bits, 1stop bit and no
parity, B/C switch set to ‘B’
.
Module 2: admin on Host EIA-232
Device A (2,1).........1
Device B (2,2).........2
Device C (2,3).........3
Device D (2,4).........4
DS-RPC (5,1).........5 DS-RPC Chassis ONLY
Configuration .................C Module setup
I/O Modules Reset ............RM Reset all I/O ports
Unit Reset ...................RU Resets DS-unit. All internal and external
communications are lost
Exit ..........................X Access to additional menu options
Logout ........................T Logout the user
Enter Request :c
NOTE:
Depending on the DS-Series model, the menus may vary according to the number of
DS74 modules installed in the unit. If this is not an initial set-up and Password has already been
enabled, you are prompted to login. After logging in successfully, invoke the main menu by
sending the attention character five times (
;;;;;
).
With a proper serial port connection, upon power-up or unit reset, a similar DS host menu
will be displayed. The number of devices ports displayed is dependent on the number of
DS74 modules installed.
NOTE:
If select the “Configure” option and get the following message
(
Configuration mode in use
), the other port has the configuration option selected.
IMPORTANT:
Any changes made in the Configuration menu will take effect when the
changes are saved. The unit will ask to save changes before exiting the configuration menu.
NOTE:
Only the Admin user will see the Configuration, Unit Reset, and I/O Module Reset
options. All users will see only the ports assigned to them, alone with ‘Exit’ and ‘Logout’.
