Bayer HealthCare RapidPoint 400 Series, Руководство по обслуживанию, Страница: 220 / 458

220 Rev. C
Message Probable Cause and Corrective Action
Service Solutions
Perform service solutions only after all other corrective actions
have taken place. If Question Results (?) are chronic, perform
the following steps:
NOTE:
Poor mixing can cause an Hct Question Result error.
1. Replace the measurement cartridge.
2. Use the cartridge simulator to perform the measurement
test. Refer to Using the Measurement Cartridge Simulator
on page 240 for information about the cartridge simulator.
3. Replace the connector block.
4. Replace the interface module.
Required QC Due Appears when the next required QC is scheduled to be
analyzed. The time period during which QC must be analyzed
appears with the message.
Touch the QC button to start the scheduled QC analysis. The
message disappears after the required QC is finished.
Sensors Unavailable
For QC Controls are currently scheduled for Required QC or
AutomaticQC analysis, but all parameters scheduled for the
next level of QC analysis are not available (for example,
because they are out of calibration).
Determine why parameters are not available and correct the
problem. Refer to
Button and Parameter Status on page 155
for more information.
SulfHb > 1.5% The system detects that Sulfa hemaglobin was detected in the
sample with an estimated concentration greater than 1.5%.
System Error.
Please wait. The
system is trying to
recover from the
error. The system detects that a condition exists that prevents routine
operation. The system is attempting to correct the problem.
You can touch
Continue
to remove the message. However, the
system remains at the Status screen and displays the
message again every 5 minutes while it tries to correct the
problem. If the system is unable to correct the problem, a
message appears prompting you to call for service.
1. Operate the system in an environment with ambient
temperature within 15 to 32°C.
2. If prompted to call for service, record the message and call
for technical assistance.
Service Solutions
View the events log for errors that may be causing the problem
and refer to the appropriate section of this manual.
(Continued)