Bayer HealthCare Certegra, Руководство по эксплуатации

Страница: 46 / 104

MEDRAD
®
Stellant CT Injection System with Certegra
®
Workstation
9 - 38
Figure 9 - 3: FluiDots
FluiDots must be viewed through fluid in the syringe. If viewed through an empty syringe, they will not
change shape. FluiDots must be viewed in a properly illuminated environment providing enough light to
permit easy viewing.
Figure 9 - 4: Properly Illuminated FluiDots
9.2.2 Install and Fill a Syringe
1.
Install a new syringe on the injector head by inserting it quickly and firmly in one motion.
NOTE:
Syringe can be inserted without consideration of alignment.
2.
If Auto Advance is enabled, the piston automatically advances and engages the syringe
plunger and then advances it to the full forward position.
• Advance plunger to the end of the syringe using the piston controls on the injector head
or manual knobs.
3.
Install the filling device (e.g. spike, Quick Fill Tube) onto the end of the syringe.
4.
Insert the filling device into the fluid source.
NOTE:
Refer to fluid manufacturer's instructions for use and/or package insert.
5.
Fill syringe using Auto Load or manually.
NOTE:
Syringe A is the contrast syringe, and Syringe B is the saline syringe.
a.
Auto Load:
i.
Press Auto Load on the injector head.
• The volume indicators on the injector head indicate how much fluid needs to
be loaded to support the displayed protocol including the amount necessary to
prime the patient tubing.
• Optionally, press the +/- keys to increase or decrease the amount of volume
loaded.
NOTE:
Selecting the Other LPCT (low pressure connector tubing) configuration setting will provide
about 6 mL of prime fluid when using one syringe, or about 6.5 mL when using two syringes.
ii.
Press Fill .
NOTE:
Auto Load disables after 10 seconds of inactivity.
Empty Syringe Filled Syringe
Mechanical Hazard - Equipment damage may result.
• Do not install disposables with excessive force.
NOTICE