Bay Networks Remote Annex 2000, Руководство по установке оборудования, Страница: 89 / 136

3-31 Remote Annex 2000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
The slip –d command displays all the current settings. The slip –d
command display looks like this:
Pressing -C interrupts the slip command; the
parameters remain unchanged until the command
completes normally.
Table 3-2. The slip Command Prompts
(continued on next page)
monitor:: slip –d
Local endpoint address: 192.9.200.214
Subnet mask: default 255.0.0.0
Remote endpoint address: 192.9.200.0
Remote load/dump host address: 192.9.200.88
This interface may be used for memory dumps
Baud rate: 38400
Stop bits: 1
Parity: none
W
ARNING
Control
Prompt Description
Allow SLIP on this
port Modifies the port’s mode. A y response changes
the port to a SLIP interface. An n response
changes the port’s mode to CLI. The port is not
available as a SLIP interface and the SLIP
parameters are ignored. The default is n.
Enter local endpoint
address Specifies the Remote Annex 2000 IP address for
this SLIP interface. The Remote Annex 2000
boots over the SLIP interface only if this address
is set.
The Remote Annex 2000 can slip boot
over any port except port 1.