Bay Networks 8000 RAC, Инструкция по установке, Страница: 49 / 148

2-5
Chapter 2 Installing the Model 8000 Remote Access Concentrator
Installing the Model 8000 Remote Access Concentrator
Installing the Remote Access Concentrator in a Rack
If you wish, you can install the RAC in an equipment rack. To do this,
you need the following equipment:
• Two mounting brackets shipped with the RAC
• Twelve #6 flathead screws shipped with the RAC
• Four #10 rackmount screws and washers shipped with the
RAC
• Phillips screwdriver
You install the RAC in a rack by attaching mounting brackets to the sides
of the device and then attaching the device to the rack.
Attaching the Mounting Brackets
To attach the mounting brackets to the RAC:
1. Remove the two mounting brackets and the 12 #6 flathead
screws from the package.
2. Line up the six holes in one mounting bracket with the six
holes on the RAC (
Figure 2-2 ).
3. Insert and tighten the six screws to secure the bracket to the
device.