baxter ExactaMix 2400 Compounder, Руководство оператора

Страница: 98 / 225

Using the Compounder
Operator Manual for the Baxter ExactaMix 2400 Compounder
Page 90 53007410 Rev. C
When compounding is finished, a message displays this information about the patient
bag:
o
Expected weight
o
Actual weight
o
Difference
o
Statement about whether or not the difference is acceptable
NOTE: If the difference is not acceptable, refer to Issues with the Weight and Load Cell
on Page 202. The acceptable difference is typically set to ± 5%. To change this setting,
refer to Acceptable Weight Variances on Page 117.
4. At the message with information about the patient bag, tap OK .
Message
Removing the Patient Bag
Always use aseptic technique when removing the bag.
1. Remove the bag’s fill port from the load cell’s fill port holder.
2. Remove the bag from the load cell.
3. Clamp the bag’s fill port.
4. Disconnect the outlet tube from the bag.
5. Connect the end of the outlet tube to the tube holder on the vial rack.
6. Cap the bag’s fill port.
Completing the Order
WARNING
It is important to inspect the finished solution to make sure that it complies with
standards.
1. Visually inspect the finished solution in the patient bag for precipitates and particulates.
Follow your facility’s protocol.
2. View and approve the MixCheck Report according to your facility’s protocol. For
instructions, refer to MixCheck Report on Page 161.
3. If necessary, perform any manual additions. Refer to Performing a Manual Addition on
Page 93.