Bavarian Demon 3SX, Инструкция по эксплуатации

Страница: 5 / 18

PREPARING THE REMOTE CONTROL
Switch off ALL mixers in the transmitter! The mixers are set only in the FBL system according to the linkage type. In the transmitter, select an unmixed standard
program (CCPM/H1, in case disable the collective tail mixing).
The functions for AVCS menu, pitch-throttle curve, or if (e.g. when scale fl ying) you want to achieve idling with the coll.pitch stick, remain in the transmitter.
CONNECTION
VIA SERVO OUTPUTS (STANDARD RECEIVER)
VIA FUTABA S.BUS OR SUM/PWM SIGNAL (ROBBE, JETI, GRAUPNER, ETC.)
If the receiver features a sum signal (PPM pulse or ‚serial PWM‘) output, it can be connected via this output, so only one cable is needed. To make use of this,
use one single cable (e.g. gyro cable), connecting it as illustrated. In this case, the throttle channel is looped through by the FBL system, its output supplied at
the neighbouring slot named “Output throttle / ESC”. Alternatively, if available, the ESC or throttle servo can remain at the reseiver‘s throttle port. Activating this
feature is done via PC software.
A further channel is available, output2, e.g. for speed controller gain, illumination accessories or retractable gear. This channel supplies only the signal pin. If
necessary, connect the power supply via a Y-cable to e.g. one of the servo ports.
5
Sum.-/PWM-Signal
VIA SATELLITE RECEIVERS (SPEKTRUM / JR)
Up to 2 (diversity) receivers can be connected, one at each side of the system. See the info texts in the PC software for activation, adjustments and satellite binding. No
main receiver is needed for binding the satellites to the transmitter! The usual input ports for tail gyro and head gyro channel must be idle, i.e. not connected to any signal
source. When using Spektrum/JR satellites, the FBL system needs to be supplied with min. 5,5V. 4,8V batteries (4x NiMH or NC) are not suffi cient!