Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 69 / 120

Commissioning
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04
69
of 118
11
X: LED status user-defined
11.8 Commissioning procedure
The commissioning process is divided into the following sections:
1 Switching on.
2 Testing the function.
11.8.1 Switching on the BMC-M-SAF-02
m
Read and observe the
Z
General safety regulations
–
from page 62 onward.
m
The “Assembly and installation” section will have to have been conducted properly.
m
Position the S2 switch/button on the b maXX safe PLC on "STOP" (middle position).
m
Switch the +24 V DC of the voltage feed on.
LEDs Meaning
H1 H2 H3 H4
⊗
X X X Control in RUN
X X X Control in STOP
X
⊗
X X Error in the control has occurred
X X X Control status OK
X X
⊗
X BLINKING: Inserted CF card detected during start-up or safety
code entry is running
X X X
⊗
BLINKING: Copy code entry is running
X X
⊗
X STEADY: Copying process from card to control running, LED goes
out once the copying process is complete
X X X
⊗
STEADY: Copying process from control to card, LED goes out once
the copying process is complete
X X X
⊗
Error has occurred during the copying process.
CAUTION!
Damage through electrical destruction.
You may not connect the b maXX safe PLC module with other system components
or separate it from other system components when the +24 V DC of the voltage feed
is on.
Therefore:
m
Switch off the +24 V DC of the voltage feed of the power supply beforehand.