Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 67 / 120

Commissioning
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04
67
of 118
11
11.7.2 Rotary switch S1 of BMC-M-SAF-02
Rotary switch S1 of BMC-M-SAF-02 is intended for future developments and is not in use
at this time.
11.7.3 S2 switch/button for changing operating statuses of the BMC-M-SAF-02
The b maXX safe PLC module has the S2 switch/button to change the operation statuses
(“K” in
Z
Figure 1
–
on page 35).
The switch affects both the standard PLC and the safety PLC (see
Z
Description of the
operation modes, RUN/STOP switch
–
from page 60 onward).
Figure 16: S2 switch on the b maXX safe PLC module of the BMC-M-SAF-02
Button in up position: RESET
Switch middle: STOP
Switch down: RUN
NOTICE!
The user project can only start up if the switch/button S2 is in the lower "RUN" posi-
tion and all modules have sent their global ready message to the b maXX safe PLC
(H4 [red] is off).
With the button in the up position, a reset is conducted for the b maXX safe PLC mod-
ule, for the power supply module for the b maXX controller/safe PLC and for the fur-
ther system components (modules which are plugged in to the left of the b maXX safe
PLC or to the right of the power supply).
DANGER!
Danger from mechanical action!
The machine/line or parts of the machine or line can be started during the commis-
sioning of the b maXX safe PLC and the power supply connected to the b maXX safe
PLC (as well as additional connected system components) by having an application
program completely ready. Improperly setting an address on the power supply (see
>
Operation Manual for the power supply for the b maXX controller/safe PLC
<
and
Z
Setting the station number
–
from page 63 onward) can cause the machine/line or
parts of the machine or line to behave in an unexpected manner.
Therefore:
m
Maintain an adequate distance from moving machine parts/line parts or from the
moving machine/line.
m
Note that the machine parts/line parts or machine/line can be set in motion via ad-
ditional modules connected to the b maXX safe PLC.
m
Activate the safety devices in any case.