Baumuller b maXX BM5800, Руководство по параметрам

Страница: 166 / 816

Configuration
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
166
of 814
3.4
106.52
Resolver phase synchronization
Setting of the phase shifting of the resolver tracks dependent on the DSP interrupt. Then
bit 4 of
Z
106.43
–
still must be activated.
Configuration examples:
–
Z
106.43
–
= 0x0003 : Resolver standard setting, resolver frequency = 7.8125 kHz
without synchronization on the fieldbus with automatic amplitude and phase setting
–
Z
106.43
–
= 0x0083 : Resolver reevaluation, resolver frequency = = 7.8125 kHz
without synchronization on the fieldbus with automatic amplitude and phase setting

_________________________________________________________________

–
Z
106.43
–
= 0x0093 : Resolver reevaluation, resolver frequency = 8 kHz with syn-
chronization on the fieldbus and automatic amplitude and phase setting


Here the required phase shift to the DSP interrupt with
>
106.52
<
can be set.
–
Z
106.43
–
= 0x0092 : Resolver reevaluation = 8 kHz with synchronization on the
fieldbus. However, with an automatic phase setting and an manual amplitude set-
ting. Here the following procedure shall be complied with:
1. Setting of
Z
106.20
–
(
Z
106.21
–
) = 0 and
Z
106.22
–
(
Z
106.23
–
) = 1024.
2. Set the excitation set-amplitude manually by
Z
106.44
–
, until the value is

displayed at
Z
14.3
–
by about 85%.
3. Set the required phase shifting to the DSP interrupt by
>
106.52
<
.
106.60
SSI mode
Setting of transmission and the data format:

Bit Meaning
9 ... 0 Reserved
13 - 10 Baud rate
Value Meaning
0 100 kHz
1 199 kHz
2 399 kHz
3 1,014 MHz
4 1,974 MHz
5 ... 15 Reserved