Baumuller b maXX 4100 Series, Руководство по эксплуатации

Страница: 43 / 144

Design and Operation
Operation manual b maXX BM4100 (NWR)
Document no.: 5.04052.09
43
of 142
4
4.6 Marking of the function modules - type key
On the front sheet you will find the type key of the plug-in module.
4.7 UL notes
m Z
Requirements to the connecting cables
–
on page 62
n
Use 60 °C/75 °C copper wire only for all devices
n
Use Class 1 wire only.
m Z
Connection diagrams
–
from page 71
n
Note tightening torque for connection terminals.
m Z
Required environmental conditions
–
on page 28
n
Use the device only in a pollution degree 2 environment
n
Observe the maximum environmental temperature and the derating
m Z
Requirements to the energy supply / supply system
–
on page 27
n
For use on a solidly grounded wye source only
n
The control circuit shall be supplied by an isolated power supply or control trans-
former rated max. 42.4 V peak, 10,000 VA.
m Z
Fuses
–
from page 116
n
BM4135 may also be protected with Type E self protected combination motor con-
troller, sized based on the rated current
n
Converters may be used with listed fuses or listed circuit breakers DIVQ as overcur-
rent protection.
cUL notes Additional only for Canada:
NOTE
This type key is valid only for permanently installed function modules of the series b
maXX 4100 . Other plug-in modules have an own type key.
BM4 - F - XXX - XX Device family, in which the plug-in module can be build in
BM4 - F - XXX - XX Plug-in module type (function module)
BM4 - F - XXX - XX Plug-in module identification
SEA:
SRM:
UME:
DIO: Main contactor control module
Main contactor monitoring module
Mains voltage sensing module
Digital I/O module
NOTE
Overvoltage Protection Device have to be installed in front of the input circuit of the
device to limit the maximum overvoltage peak to 2.5 kV.