Baumr-AG BMLAT-05, Руководство пользователя

Страница: 21 / 46

E&OE © 2020 Baumr-AG 21
9. Repeat these procedures at HIGH range setting.
CAUTION ! NEVER attempt to change from HIGH to LOW range setting when the machine is running.
Starting Under Normal Conditions
1. Take all the necessary precautions previously stated and ensure the workpiece is firmly secured.
2. Set the Speed range control lever to HIGH or LOW, as needed.
3. Proceed to start the machine as described above.
ATTENTION : The power supply system of this machine has an auto over-load protective function. If the feeding
is too fast or drilling is too deep, the system will stop working and the yellow LED (B) will light-up. Just turn off
the Variable Speed Control Knob (D) and then turn it ON again. The system will work again and the yellow LED
will turn OFF automatically.
Drilling or Deep Milling
1. As per Installation and Removal of the Taper Shank , install an appropriate adjustment and tighten it
securely.
2. Select an appropriate speed level.
WARNING! When the spindle is running, DON’T change the speed setting.
3. Using the fixture, secure the workpiece on the working table.
4. Adjust working table (longitudinal Axis Y) and the saddle seat (Cross Axis X) into position.
5. Loosen the limit block handle and adjust the blocks into position.
NOTE
: Ensure that the workpiece doesn’t come in contact the tool.
6. Put the adjusting tools in order and remove all obstacles and debris around the machine.
7. Turn the main power ON. Adjust the appropriate spindle speed for drilling or deep milling.
8. Refer to the ruler on the fuselage to measure the drilling or milling depth.
9. When finished with your work, turn OFF the power and take the spindle to the upper position.
10. Clean the machine.
Face Milling
1. As per Installation and Removal of the Taper Shank , install an appropriate adjustment and tighten it
securely.
2. Select an appropriate speed level.
WARNING! When the spindle is running, DON’T change the speed setting.
3. Using the fixture, secure the workpiece on the working table.
4. Adjust working table (longitudinal Axis Y) and the saddle seat (Cross Axis X) into position.
5. Release the limit block on the fuselage, adjust the cutting depth then fix it into position.
6. Arrange all tools into their proper positions.
7. Turn the hand wheel of the working table (Y-axis) and the saddle seat (X-axis) to perform face milling.
8. Finishing all the steps, turn the power OFF and take the spindle back to the upper position, then you can
take out the workpiece.