E&OE
© 2020 Baumr-AG
18
Installation and Removal of the Taper Shank
Installation
1. Turn off the main power before you replace the
cutter.
2. Pull out the protective cover (a).
3. Wipe the spindle sleeve and taper shank.
4. Put the taper shank (g) into the spindle sleeve.
Cutter should be matted with oil cloth to ensure the
safety of the machine and your fingers.
5. Insert the Fixing Pin (d) right on the spindle sleeve.
6. Use a #l4 open end wrench (c) to tighten the spindle
draw bar (b) in a clockwise direction to secure the
taper shank.
7. Pull out the fixing pin.
8. Install the protective cover (a).
Removal
1. Turn off the main power before you replace the
cutter.
2. Pull out the protective cover (a).
3. Insert the fixing pin (d) right on the spindle sleeve.
4. Use a #14 open end wrench (c) to loosen the
spindle draw bar (b) in an anti-clockwise direction.
5. Knock the taper shank (g) gently with a plastic
hammer to loosen it in the spindle sleeve. Then,
take off the taper shank (g).
6. Cutter should be matted with an oil cloth to ensure the safety of the machine and your fingers.
7. Re-install the protective cover (a).
IMPORTANT
! For your safety, any adjustments on the machine should be done only when it is already
unplugged from the mains power supply.
Adjusting the Spindle Box
Using the limit block, you can control the traveling rate of the spindle box.
1. Loosen the handle (a) beside the limit block (b).
2. Adjust the limit block (b) into the desired position.
3. Tighten the handle.
4. Travel position can refer to the ruler on the fuselage rotary.
