E&OE
© 2020 Baumr-AG
17
Installation
Location Set-Up
The machine should be fixed on a flat and secure worktable with four hexagon bolts. Install it at an appropriate
location in order to fully-utilised the precision requirements of the machine.
Selecting an Appropriate Location
•
The worktable should have a flat, stable surface.
•
Avoid placing it under direct sunlight or areas with heavy dust and moisture.
Securing the Mill Drill
1. Drill four holes on the worktable. Dimensions should be the same as the holes on the machine's base.
NOTE
: Consider the Y-axis handwheel when choosing a suitable location for the machine.
2. Adjust the machine accordingly and secure it to the worktable with 4 M10 bolts and nuts.
Checklist Before Switching ON the Machine
•
Remove all fixtures which that might impede the normal operation of the machine.
•
Check whether the power voltage is suited to the machine (see label in front of the machine).
•
Remove all obstacles and debris around the machine.
•
Remove the anti-rust protection before affixing the machine.
•
Check the angle of the pillar and adjust the bolts to see if they are tight enough.
•
Check the chuck, chuck holder and fixing pin on the spindle to ensure they are unloaded.
•
Check the High-Low speed on spindle to see if it
’s set on the right speed setting.
•
Turn on the machine and check the direction of the spindle rotation (should be clockwise).
•
Run the Longitudinal Axis (Working table), Cross Axis (Saddle seat) and Vertical Axis (Fuselage) to ensure
they’re in normal condition.
•
Be aware always while operating the machine. If you notice anything unusual, immediately stop using the
machine and have it repaired immediately.
