Baumer VisiLine, Руководство пользователя

Страница: 41 / 68

41
Configurable 9.6.1.2 Outputs
With this feature, Baumer offers the possibility of wiring the output connectors to internal
signals, which are controlled on the software side.
Hereby on VisiLine IP cameras, the output connector can be wired to one of provided
internal signal: "Off", "ExposureActive", "Line 0", "Timer 1 … 3", "ReadoutActive", "User0
… 2", "TriggerReady", "TriggerOverlapped", "TriggerSkipped", "Sequencer Output 0 ... 2".
Beside this, the output can be disabled.
(Output) Line 1
state high
state low
(Output) Line 2
state high
state low
(Output) Line 3
state high
state low
IO Matrix
state selection
(inverter)
signal selection
(software side)
Off
Line0
TriggerReady
TriggerOverlapped
TriggerSkipped
ExposureActive
ReadoutActive
UserOutput0
UserOutput1
UserOutput2
Timer1Active
Timer2Active
Timer3Active
SequencerOutput0
SequencerOutput1
SequencerOutput2
User defined Signals
nternal Signals
Loopthroughed
Signals
1
2
3
4
5 6
7
8
9.6.2 IO Circuits
Notice
Low Active: At this wiring, only one consumer can be connected. When all Output pins
(1, 2, 3) connected to IO_GND, then current flows through the resistor as soon as one
Output is switched. If only one output connected to IO_GND, then this one is only us-
able.
The other two outputs are not usable and may not be connected (e.g. IO Power V
CC
)!
Output high active Output low active Input
Camera Customer Device
IO Power VCC
U
ext
Pin
RL
IOUT
IO GND
Out (n)
Pin
Camera Customer Device
IO Power VCC
RL
IOUT
IO GND
Out
U
ext
Pin (Out1, 2, 3)
Out1 or Out2
or Out3
Camera Customer Device
IO GND
DRV
IN1 Pin
IN GND Pin
◄ Figure 32
IO matrix of the
Baumer VisiLine IP on
output side.