Baumer Hubner HMC16 Series, Монтаж и эксплуатация

Страница: 14 / 44

MOUNTING / TIGHTEN THE CLAMPING RING SCREW AND ADjUST THE SySTEM
10/40 MB168T1EN - 11184527, 19A2, Baumer_HMC16-T1_II_EN
* Siehe
page 6
4.3 Tighten the clamping ring screw and adjust the system
)
Check the flush alignment of the rotor and the stator front edge and adjust correct
distance between stator and clamping ring front edge, see figure.
2 * 3 * 1 * 4 *
Radial tolerance
Axial tolerance
-0�2 mm
-2 mm
+0�2 mm
+2 mm
Max� tightening torque:
M
t
= 3 ��� 4 Nm
15 mm
0
0
0�4 mm
Nominal air gap
1
*
2
*
4*