Attach to your desk
(mounting to edge of desk)
Attach to your desk
(mounting to desk cable opening)
Have you got everything?
Unpack the box (be gentle) and make sure all of these items are there:
Adhere the bracket clamp cover to the support block
and attach the clamp to the base with the cap screw.
Use the 4mm hex key to tighten.
Remove the screw from the bracket clamp in order
to remove the tightening bolt completely from the
clamp. Put the screw back in.
Tighten the bracket clamp from beneath by turning
the adjuster clockwise and make sure it’s tight.
Slide the base cover on and clip into place.
Place the pole in position and screw in the clamp from
below. Tighten the securing screw from beneath by
turning the adjuster clockwise and make sure it’s tight.
Nearly done! Just a bit more on
the other side of this page...
Hey!
Let’s get your new monitor
bracket ready to use, fast!
Quick Start Guide
Model: AMAB-0619-D
1
2
2
1
Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table
Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table
You will also need
a Phillips-head
screwdriver
to secure your
monitors to the
bracket
A. Pole
B. Monitor arms
C. M4 x 8mm screws (x8)
D. M4 x 16mm screws (x8)
E. Screw spacers (x16)
F. 4mm hex key
G. 5mm hex key
H. Cap screw
I. Bracket clamp cover
J. Bracket clamp
K. Pole cover
L. Pole cable clip
M. Monitor arm cable clips (x4)
N. Pole cover
O. Warranty Card
P. Quick Start Guide
O
P
H
I
F
J
K
L
M
N
