Bauer G 120 II V, Инструкция по эксплуатации и список запасных частей

Страница: 16 / 138

G 120 II V
Page 6 1st Edition, Rev. 0 Chg. 2
2.1.2 Operator Interface
The Operator Interface is a 4.3 inch, 256 color, 8 bit LCD with touchscreen operation. The Operator
Interface is the input/output device for normal operation of the compressor unit. The compressor system
is ready and able to operate after the Emergency Stop Switch is pulled out and the red “COM” status light
illuminates. The red status light will continuously strobe to show that the unit is ready.
2.1.2.1
Run Screen
The initial screen after startup allows control and monitoring of the compressor unit.
1. If the unit is equipped with a CO monitor, the words (CO) monitor are shown here. Also if the unit
is equipped with a Securus or Seccant monitor, the status of the monitor is shown here.
2. This reading shows the current run time of the compressor in hours. Once the compressor is turned
off this reading returns to zero. For total hours on the unit check the status screen.
3. This reading tells when the next maintenance is due on the compressor.
4. These lights show the status of electrical connections and communication. The red light strobes
continuously to show communication is established with the PLC. The green light indicates that the
PLC has power, and the yellow light indicates power is coming into the unit.
Figure 2-3
Maple System; Run Screen
1. Securus / Secant Status
2. Current Run Time
3. Next Maintenance Due Status
4. Status Lights
5. ON & OFF Buttons 6. Closes Window (goes to main menu)
7. Current Time & Date
8. Final Pressure (from sensor)
9. Current Oil Pressure (from sensor)
10. Inlet Pressure (if equipped with sensor)
1
2
3
4 5
6
7
8
9
10
(CO) MONITOR
SECURUS