Thank you for purchasing a Tipton Gun Vise. Assembly of this product is very easy and requires only a Phillips head
screwdriver. Please take a moment to locate all of the parts shown in the photo below.
1. . . . . . . . . . . . . . . . . .
Gun Vise Base Assembly (1018466)
2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Clamp Pad (203931)
3. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Forend Pad (1018468)
4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Grip Pad (1000076)
5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear Pad (1000077)
6. . . . . . . . . . . . . . . . . . . . . . . . .
Pivot Arm Cover (1015872)
7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cam (527772)
8. . . . . . . . . . . . . . . . . . . . . .
Cam Lever Assembly (432410)
9. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pivot Arm Pin (242621)
10. . . . . . . . . . . . . . . . . . . . . .
Pivot Arm Assembly (318636)
11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Spring (539059)
12. . . . . . . . . . .
(3) ¼-20 x 1.25 Pan Head Screws (138037)
ASSEMBLY INSTRUCTIONS:
A: Pivot Arm Assembly
1. Press the Clamp Pad over the
steel washer on the Pivot Arm.
2. Insert the Pivot Arm Pin into
the large hole in the vise.
3. Install the Pivot Arm onto the pin.
NOTE: The Arm should be oriented
so that the Spring Alignment Stud
is even with the Spring Groove
as shown.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
A: Pivot Arm Assembly
continued
4. Slide one end of the Spring onto the
Alignment Stud and place the body
of the spring into the Spring Groove.
5. Now place the Pivot Arm Cover over
the Pivot Arm Pin and secure it with
two of the provided Screws.
NOTE: Do not over tighten
the screws. Over tightening
the screws can strip out the
plastic base.
1.
2.
3.
NOTE
4.
5.
B: Cam Assembly
1. Hold the Cam in one hand and the Cam Lever Assembly
in the other hand as shown.
2. Insert the Cam Lever into the Cam so that the Roll Pin snaps
into the slot in the Cam. The completed Cam Assembly should
be oriented like below.
3. Now slide the bottom of the Cam Lever into the hole in the
Base and secure the Cam Cover with the remaining Screw.
1.
2.
Assembled
Cam Lever
3.
A Product
5885 West Van Horn Tavern Road
Columbia MO. 65203
Visit our website at www.tiptonshooting.com
Screw Hole