•
Be sure to install LED NeonFlex in maintainable places.
•
Avoid using excessive force during installation in order to minimize the risk of damage to LED NeonFlex or cabling.
•
Be careful not to go beyond the recommended maximum quantities of LED NeonFlex for a given power supply. Overload may cause blinking,
uneven illumination or failure.
•
These LED NeonFlex are designed to work with constant-voltage power supplies. Use only recommended power supplies. Do not connect to
constant-current power supplies, as doing so will cause immediate failure of LED NeonFlex .
•
Please install LED NeonFlex using appropriate appliance wiring material and cables.
•
Make sure to provide sufficient ventilation and rainwater drainage for the installation containing the LED NeonFlex to prevent shortening their
lifetime due to excess heat, long-term exposure to water or ice damage. Operating temperature should be within -20~60 ºC.
1.
Prepare the screws and clips / profile.
Tools:
Wires connectors, screwdriver and screws; PC, aluminum
clips, or aluminum profile depending on the needs.
2.
Adjust the clips / profile to the appropiate place,
use a screwdriver to fix the screws.
3.
Insert NeonFlex strip into the fixed clips / aluminium
profile / installation chain in one direction putting the
light emmiting surface upwards.
4.
Choose a 24 VDC power supply. Then, connect
the red wire (+) of the NeonFlex to the positive wire
(+) of the power supply. Connect the black wire (-)
to the negative wire (-) of power supply. Use
waterproof connectors for IP67 connection.
2/
2
© 2021, All rights reserved BaltLED, UAB. Specifications are subject to change without notice.
www.baltled.com
July
1st
, 2021
NEONFLEX
installation guide
FOR LONG-LASTING PERFORMANCE
5.
Finish by connecting the AC power line to the
input wires of the power supply.
FOR LONG-LASTING PERFORMANCE
CUTTING NEONFLEX
1.
Cut the desired NeonFlex length only
between solder pads. Cutting point is marked.
Tools:
Utility knife or cable cutter for cutting; power
connector, end cap & silicone.
2.
Put silicone into end cap/power connector and
firmly push cut NeonFlex into it. Don't leave NeonFlex
ends uncapped.
SAFETY PRECAUTIONS:
✖
Do not twist NeonFlex.
✖
Do not bend the NeonFlex very aggressively.
✖
Do not hang or suspend NeonFlex in air.
✖
Do not exceed max continuous strip length.
✖
Do not exceed max bending diameter.
BE CAREFUL:
✓
Only bend in recommended directions (side bending /
convex (top) bending )
✓
Make a clean vertical cut when cutting NeonFlex to
avoid damage.
✓
Leave 5-10mm distance between individual strips of
NeonFlex.
MAKE SURE TO:
