TEA KICK v1.0 Brief Assembly guide
This is a brief guide
for more advanced
users. If you are a
beginner please look
for the detailed guide
on our website.
Start by populating
and
soldering
the
boards
with
the
shortest and smallest
parts. Taking care of
the values, polarity
and alignment of the components.
Note:
The crossed out resistor value at the lower part of the board is 1M.
Note:
The protective fuses look quite similar to ceramic capacitors but are placed in the
blank rectangular markings on the board.
To ensure that all the connectors are properly aligned, solder them with the two boards
connected and screwed together. The same goes for the UI components, solder them with
the front panel secured in place.
The finished bottom board should look like the one to the left.
