Bastl Instruments SoftPop, Руководство пользователя

Страница: 4 / 27

Cutoff level fader.
Adjusts the
tone of the filter from high to low.
Modulation fader.
Applies
modulation to the cutoff of VCF.
The source of modulation is normalized
(internally connected) from a mix of
VCO0 + VCO1 . This signal can be
partially overridden by patching a signal
into the
MOD socket in the patchbay.
Feedback thumbwheel.
Use this
to increase the “sharpness” of the filter
and introduce self-oscillation. Increasing
feedback (also known as resonance
or regeneration) of the filter will also
increase signal distortion at certain
cutoff levels.
*See the “Patchbay” section for more info on
connecting signals in and out of VCF.
VOLTAGE CONTROLLED
OSCILLATOR 1 (VCO1)
VCO1 has 4 controls:
Pitch fader.
Adjusts the pitch
from LFO to audio ranges.
Modulation fader.
Applies
modulation to the pitch of VCO1.
Modulation will affect pitch and wave
shape. The source of modulation
is normalized (internally connected)
to a mix of VCO0 + VCO1 inverted
and the EXT (external input) jack
and socket. This signal can be partially
overridden by patching a signal into
the VCO1 MOD socket in the patchbay.
Mode switch and button.
Switches the running mode of VCO1 from
a repeating oscillation to a one-shot
envelope. The envelope can be triggered
with the mode button as well as the
VCO1 SYNC input socket.
*See the “Patchbay” section for more info on
connecting signals in and out of VCO1.
PATTERN GENERATOR
and QUANTIZER
See “Let’s make a pattern” section for more info.
PATCHBAY
(outline = output; no outline = input)
Cross-patch the guts of softPop or
connect to external gear to make
something crazy happen.
*See the “Patchbay” section for more info
on using the patchbay.
SOCKET TO JACK
ADAPTERS. (A, B, C)
Allows any socket in the patchbay to
be connected to external equipment.
*See the “Patchbay” section for more info
on using the patchbay.
ROUTING SWITCHES
Led switch.
Turns the little magic
color orb on or off.
-(0+1) switch.
In the down position,
it will disconnect VCO0 and VCO1 from
the input of VCF
. This is useful if
using softPop only as a filter for external
audio signals. VCO0 and VCO1 will still be
available as modulation signals but will
not enter the audio path of VCF unless
manually patched into the VCF
EXT
input socket.
Mix switch.
In the up position, it
routes some of the dry signal from the
EXT input jack directly to the final mix.
This gives you a mix of the filtered and
unfiltered signals.
CYCLE
freeze VCO
ENVELOPE
trigger envelope
VCO1 / MOD triangle out square out
Introduction
B