Bastl Instruments DUDE v1.2, Инструкция по сборке

Страница: 13 / 18

CLEANING
​ ​
(OPTIONAL)
Before you begin to move forward, you might want to
​ clean
your PCB. You can use e.g. isopropyl
alcohol. Put some of the liquid all over the PCB using the brush, let it act for a while and sweep it off.
Then ​ ​ just ​ ​ let ​ ​ it ​ ​ dry. ​ ​ You ​ ​ can ​ ​ repeat ​ ​ these ​ ​ steps ​ ​ until ​ ​ you ​ ​ are ​ ​ satisfied ​ ​ with ​ ​ the ​ ​ result.
ICs
Don’t forget to place the two ​ ICs into the sockets ( ​ NE5532P ​ ). There is a signed ​ notch on each IC
that has to match with the ​ notch on the socket ​ . Installing ICs can be also a little tricky. You should
bend the IC leads in slightly with your fingers first. Then press all the leads into the sockets in one
shot
13