Basler Vision Technologies Sprint Series, Руководство пользователя

Страница: 165 / 236

Configuring the Camera
Basler sprint Mono Cameras 155
7 Configuring the Camera
The camera comes with a factory set of parameters that will work properly for most applications with
only minor changes. For normal operation, the following parameters are usually configured by the
user:
„
Video data output mode
„
Line acquisition mode
„
Exposure time control mode
„
Exposure time (for ExSync programmable or free run programmable exposure modes)
„
Line period (for free run exposure modes)
To customize operation for your particular application, the following parameters may also need to
be configured:
„
Gain
„
Offset
„
Area of interest
„
Stamp
„
Shading correction
The camera is programmable via the RS-644 serial connection that is integrated into the Camera
Link interface between the frame grabber and the camera. Two methods can be used to change the
camera’s parameters:
„
The first and easier approach is to change the parameters using the Camera Configuration
Tool Plus (CCT+). The CCT+ is especially useful during initial camera testing and the camera
design in process. See Section 7.1 on
page 156 for more information about the configuration
tool.
„
You can also change the parameters directly from within your application software by using
binary read/write commands to set values in the camera’s registers (see Section 7.2 on
page 157 ).