Basler Vision Technologies Sprint Series, Руководство пользователя

Страница: 161 / 236

Features
Basler sprint Mono Cameras 151
6.12.1 Saving the Work Set to a User Set File
As mentioned above, the work configuration set is stored in the camera’s volatile memory and the
parameter settings in the work set are lost if the camera is reset or if power is switched off. The
camera can save the current work set values in the volatile memory to files in the camera’s non-
volatile memory. Files in the non-volatile memory are not lost at reset or power off. There are four
files available for holding a saved user configuration set:
UserSet01 , UserSet02 , UserSet03 , and
UserSet04 . Saved configuration sets are commonly referred to as “user configuration sets” or “user
sets.”
Saving a User Configuration Set
You can save the current work set to one of the files in the non-volatile memory by using the Camera
Configuration Tool Plus (CCT+) or by using binary read/write commands from within your own
application to set the camera’s control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156 ), you use the File Name Select parameter and the
Copy button in the User Set Files parameters group. Clicking the copy button will copy the work set
settings to the selected user set file in the non-volatile memory.
By Setting CSRs
You can save the current work set settings to a file in the non-volatile memory by writing values to
the bulk data CSR for configuration sets.
Section 7.2.3 on page 188 explains the bulk data CSRs and explains how to use the CSRs to save
the work set to a user set file. Section 7.3.1 on page 197 explains using read/write commands.
Note
For 8k cameras, only two user sets ( UserSet01 and UserSet02 ) are available.