READ AND UNDERSTAND ALL OF THESE INSTRUCTIONS BEFORE BEGINNING THIS WORK.
POLE ROPE REPLACEMENT PROCEDURE
USE YOUR PHONE
TO TAKE A PICTURE
OF YOUR PATRIOT
BEFORE YOU BEGIN.
TOOLS YOU WILL NEED:
Sharp Knife, Screwdriver,
Pump Pliers, Vise and a Hammer.
No. 76PAT-ORC
Pole Rope, Colligo Rope Clamp plus 4
Alignment Screws and 14 Rope Screws
No. 76PAT-OR
Pole Rope Only
1. Remove the old rope by cutting the line, and pulling the
pieces out of the adjustor and the connector body.
[A]
2. Remove the nylon wire tie from the end of the factory
formed loop end and straighten the line.
3. Insert the replacement line into the adjustor, then slide the
adjustor down to the end termination of the pole rope. This
will keep these parts out of the way as you work.
[B]
4. Insert the free or whip end of the replacement pole rope
into hole #1 of the connector body, pulling section with the
factory formed loop past the end, then insert the whip end
into hole #2 and pull the end through.
[C]
5. Match the alignment marks. The rope should take a natural
set on the factory formed loop. One set of marks is for the
ends, the other to position the rope clamp.
[C]
INSPECT ALL PATRIOT COMPONENTS PRIOR TO REPLACING THE POLE ROPE.
• All hardware must be free of any signs of stress, cracks, indications of electrical contact or extreme wear.
• The red wear indicator on the Red/White/Blue inner line should not be visible.
• The carabiner, connector slot and connector latch should be free from debris, open easily and close completely.
If any of the components fail the inspection, do not continue with the pole rope replacement. The failed equipment
must be removed from service.
C
A
B
1
2
