Installation / Assembly
dizzer® XL Series Modules for Open Platform
– Assembly Instructions 1.1(2019-01) E inge
Page 28 of 44
© inge GmbH
5.3
Preparing for Assembly
5.3.1
Checking the Available Space
NOTE
CAUTION, PROPERTY DAMAGE!
Potential damage due to exposure to the weather or impermissible
temperatures.
Weather and Temperature Protection
At the location where you are planning to erect the dizzer
®
XL Series Modules, ensure the following:
The unit is always protected by a roof
Permanent protection against the weather is provided
The temperatures are always within the permissible temperature range from 0 °C to +40 °C.
Space Conditions
Check the space conditions around the assembly area.
Ensure that there is enough space to allow the dizzer
®
XL Series Modules to be installed,
disassembled and operated safely.
CAUTION
DANGER OF INJURY!
Danger of injury due to constricted space.
Provide for sufficient space!
Floor Characteristics
Ensure that the floor characteristics meet the following minimum requirements
Level, smooth surface with the necessary strength
Recommendation: positioning of gullies and drainage channels ensures adequate water
drainage, e.g. when emptying the dizzer
®
XL Series Modules.
