Installation Manual
© 2014 basalt
e v2.0
SENTIDO KNX
A
RGB LED
B
Programming button
C
Temperature sensor
D
Programming LED
E
Touch sensor (
1-4
)
Safety instructions
Before operating the unit, please read this manual thoroughly and retain it for future reference.
Failure to observe these instructions might damage the device.
The device may only be installed and connected by professional electricians.
All relevant rules and regulations valid in the country of use, as well as KNX guidelines, apply.
Description
Sentido KNX is a touch-sensitive switch compatible with all Sentido and Enzo fronts, either two-way or four-way. The separate
touch-sensitive surfaces of Sentido each control various functions, such as switching, dimming, operating blinds, calling up and or
saving scenes, using both short and long press. By touching more than one surface at the same time, additional comfort functions
can be activated including room toggle, scene sequencer and RGB sequencer.
The multicolour LED backlight provides status feedback and can be used as nightlight. Sentido also has a built-in temperature
sensor and integrated thermostat logic.
A scene controller can control up to 6 scenes and 8 outputs per scene.
Components
Important advice
•
Never connect the device to 230 V.
•
Avoid obstacles which might obstruct the proper mounting of the cover to the switch, such as round headed screws,
plastering or textured wall paint.
•
Installing a Sentido on a metal wall or a mirror surface might cause the device not to function properly.
•
The minimum gap between 2 Sentidos must be at least 2cm, preferably 4 cm.
•
Do not install any device nearby that might cause interference such as fluorescent lights or RF devices.
Sentido front cover 2 way
Model No. 201-xx
(Not included)
Sentido front cover 4 way
Model No. 202-xx
(Not included)
Sentido KNX
Model No. 200-02
F
Touch-sensitive surface
G
Transparent window
A
B
C
D
E
F
F
G
G
1
2
3
4
