- 39 -
7. Possible Malfunctions
In case of malfunction, disconnect the device from its power source. Before contacting
the service or sales agent, verify - based on the table below - whether it is possible to
eliminate disruption in operation.
Problem
Possible cause
Solution
The juice
extractor does
not start after
switching on
Plug improperly connected.
Inactive safety switch,
check the position of the
locking arm.
Pull the plug and reconnect it
to its socket properly.
Follow the instructions of the
section
5.1
“Assembly”
.
Strange noise
during the
operation
Incorrectly assembled juice
extractor.
A part of the device is
damaged.
Follow the instructions of the
section
5.1
“Assembly”
.
Contact the sales agent.
The device
vibrates
The pulp container is full.
Due to the sticking pulp,
the sieve cannot keep
proper balance.
Empty the pulp container.
Switch the device off and
clean the sieve (follow the
instructions of section
6
“Cleaning”
).
The motor
appears to
struggle during
operation
The pulp container is full.
Empty the pulp container.
Pulp is sticking to the lid.
Switch the device off releasing
the locking arm, remove the
lid and remove the pulp.
Follow the instructions of
section
6 “Cleaning”
.
Reduce the pace of juicing
–
move the plunger slower in
the feed chute.
The sieve is clogged by the
pulp/pulp after processing
a bigger quantity of fibrous
fruits/vegetables.
Stop the extraction, switch the
device off and disassemble it
according to the instructions
of section
6 “Cleaning”
and
clean the sieve and the lid, if
necessary.
