Barton 94015, Инструкция по эксплуатации и правила безопасности

Страница: 6 / 9

5
OPERATION
NOTE: Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged please call our customer service.
1.
This unit should be properly grounded for your safety. The power cord of this appliance
is equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 110~120 volt, 60Hz electrical outlet with three-prong
ground.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging the
drain cap on the side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution
and warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use, open water drained cap to drain water completely from
water reservoir.
MAKING THE ICE-CUBE
1. Select the size of the ice cube by pressing the “Select” button. If the room temperature is
lower than 60°F, it is recommended to select the small or medium ice sign button in order to
avoid ice sticking together.
2. Press “ POWER ” on the control panel to begin the ice making cycle.
3. The ice making cycle lasts 6 to 12 minutes, depending on the size of the ice cube selection.
4. If water pump can’t inject water, the ice maker will stop automatically, and the “ ADD
WATER ” indicator will be on, on the operation panel. Please check the water bottle and
replace a new bottle full of water. Press “ POWER ” button again to start the unit again. Allow
the refrigerant liquid inside the compressor at least 3 minutes to settle before restarting.
3. The ice maker automatically stops working when the ICE light on the operarion panel is
on means that ice basket is full.