BARTINGTON INSTRUMENTS
Page 6 of 21 OM3224/4
4.2. Rear Panel
Figure 2. Rear view of CU1 Control Unit
Key
6. Mains input IEC socket
8. Connector 1
7. Earth terminal post
9. Connector 0
4.2.1. Rear Panel Connectors
Mains Input IEC Socket [6]:
this is for connection of an IEC lead. See datasheet DS2613 for
supply voltage.
Earth terminal post [7]:
if an appropriate earth/ground connection is not provided through the
mains supply lead, connect this terminal post to the National Instruments system chassis earth
terminal, the instrument rack earth, or a permanent earth ground.
Connector 0 [8]:
this is a National Instruments system interface socket for connection to the
National Instruments system DAQ module.
Connector 1 [9]:
as Connector 0.
5. Compatibility
The CU1 Control Unit is compatible with Bartington Instruments PA1 for use in Bartington
Helmholtz Coil System. The CU1 is also compatible for use with the CU2 Closed-Loop Module.
A range of National Instruments card can directly connect to the CU1. A non-exhaustive list of
compatible card is included here:
• NI-PXI-6289 Card + compatible Chassis and Controller and connection cables
• NI-PCIe-6353 + connection cables
• NI-USB-6363 + connection cables
6
7
8
9
