Bartec Tech200BT, Руководство пользователя

Страница: 19 / 44

Tech200BT User Guide rev3.0 April 2014
3.0 TOOL POSITIONING/READING A SENSOR
Proper tool positioning is important to ensure
sensor activation and decode. Place the Tech 200
on the tire, at the TPMS sensor, pointed toward
the sensor location as shown.
3.1 Sensor Activation/ Test LF Activated Sensors
To test a sensor the tool should be
placed alongside the valve stem and
the ‘Test’ key pressed.
(Note with Ford Banded sensor’s, the tool
should be held 180° away from the stem.)
3.2 Magnet Activated Sensors
If the TPM requires a magnet, place the
magnet over the stem and then place
the tool alongside the stem- while
pressing the test key.
3.3 Delta P activated sensors
If the sensor requires tire deflation (of the order of 10PSI), then deflate the tire
and place the tool alongside the stem while pressing the test key.
19