Bartec TC26ex-NI, Быстрый старт

Страница: 10 / 64

Basic safety information
TC26
ex
-NI - Touch Computer
Type B7-A2C*-****/********
4/56
Subject to technical changes.
June 2022
1.6 Maintenance
The pertinent erection and operating provisions for electrical systems must be observed!
(e.g. Directive 2014/34/EU, BetrSichV and nationally applicable ordinances
EN/IEC 60079-14 and the series DIN VDE 0100)!
Observe the national waste disposal regulations when disposing of the devices.
1.6.1 Servicing
No constant servicing will be necessary if operated correctly under consideration of the
assembly instructions and environmental conditions.
1.6.2 Inspection
According to EN/IEC 60079-17 and EN/IEC 60079-19 the operator of electrical systems in
hazardous areas is obliged to have these inspected by an electrician to ensure correct
condition.
1.6.3 Repairs
Repairs to explosion-protected devices may only be performed by authorized personnel
with original spare parts and according to the state of the art.
Therefore all repairs to the Touch Computer have to conducted by BARTEC.
Contact information and instructions for repair requests and processing can be found at:
https://www.bartec.de/en/service/automation-enterprise-mobility/

Procedure guide

RMA Form
1.6.4 Commissioning
It must be checked that all components and documents are available before commissioning.
1.7 Labelling, test certificate, and standards
Labels on explosion protection and the test certificate are attached to the Touch Computer.
Labelling see Chapter: Technical data.
The guidelines and standards applicable to the Touch Computer for devices and protected
systems for intended use in hazardous areas are provided in Chapter: Declaration of
Conformity.