43
5.2 Status
This page displays information about the SB. The page is updated automatically.
•
ID
contains:
o
Name
of the MR3000SB (by default this is mr3000, followed by a dash and its serial
number). You may change the name, according to your needs (see Section 5.4.1).
o
Comment
, for example a description of the location where you have installed the SB.
This text is shown together with the name in the messages (see Section 5.4.1).
o
UID
unit ID (serial number) – can not be changed
o
firmware version.
Sensor
tells you for which sensor the SB is configured.
Activity
reports the current activity of the data acquisition services:
o
Trigger
shows 3 different states:
idle: the SB is not recording an event
recording: the SB is currently recording an event
triggering: one of the trigger conditions is fulfilled and the SB is recording until the
post-event time is elapsed.
o
Background
: this shows if the SB is currently recording a peak file (file name) or not
(idle).
o
FTP backup
: shows 4 different states:
in progress: currently a file is sent to the FTP server.
errors: errors occurred when communicating to the FTP server.
idle: service is active, but there is no new file to be copied.
disabled: service is not active.
o
FTP push
: shows 4 different states:
Pushing N files: after starting the service the number of files to be sent is shown.
N files pending: N files are waiting to be sent in case of trouble or many files have
been recorded recently and have not been transferred yet, eg. due to slow
communication.
idle: service is active, but no scheduled push is currently going on.
disabled: service is not active.
o
Timed recordings
: shows 3 different states:
active: the SB is either recording (see trigger status above) or in the period
between two scheduled recordings.
idle: service is active, but start time has not been reached yet.
disabled: service is not active.
LAN
displays the
IP
address of the SB on the Ethernet port or FO, and the
MAC
address of
the interface.
