Bartec HYGROPHIL H 4230-10 A Series, Руководство по эксплуатации

Страница: 116 / 122

PROFIBUS
110
Operating Instructions HYGROPHIL® H 4230-10 Serie A BA 030520
DaAdr $48: T2 correct config
Format: Char
Before you can write this variable you must first change to standby mode.
0x00 = No correction of HT based on the T2 measurement
0x80 = HT is corrected based on T2 (internal temperature) (default)
8.3.6 2-channel parameters
DaAdr (hex) Identifier Memory type Read-out Format
$50 PropValveControlStatus RAM read/write hex Record
$54 PumpControlStatus RAM read/write hex Char
$55 PumpConfig EEPROM read/write hex Char
$57 EquipmentControlStatus RAM read/write hex Char
$58 EquipmentConfig EEPROM read/write hex Char
$53 Limit Task Config. EEPROM read/write hex Char [2]
$5a Limit LOW EEPROM read/write dec Float
$5b Limit HIGH EEPROM read/write dec Float
DaAdr $50: PropValveControlStatus
Format: Record
Statuschar: Char;
ControlStatusChar: Char;
ON time; Integer;
OFF time; Integer;
End;
StatusChar:
7 6 5 4 3 2 1 0
ON OpenError CloseError Free Free Free Free Free
ON: 1 = Controller is switched on and working
0 = Controller off
OpenError:
1 = Flow rate too low, valve cannot be opened any further
0 = Valve in working range < maximum
CloseError
1 = Flow rate too high, valve cannot be closed any further
0 = Valve in working range > minimum