BARTEC BENKE HYGROPHIL F 5673, Руководство по эксплуатации, Страница: 53 / 129

Operation
4-7
HYGROPHIL® F 5673 Operating manual, Software version 1.8.x, 387896MDHEN(14.06.2013)
4.3.4 Online graphic display
In the online graphic display, the measurement value curve of the measure-
ment variables of line 1, 2 and 3 for the last 2 hours is presented.
To distinguish the curves, they are marked with different symbols (x,
□, ○).
As only one scaling is used for the measurement value axis, the measure-
ment values are multiplied by powers of ten so that they can be presented
within the value range of the measurement value scale.
In the line below the graphic, you find some information on the three meas-
urement value curves presented. The “O“ at the beginning of this line stands
for “Online“ und serves to distinguish this mode from the “History graphic
mode“ („H“).
Every 30 seconds a new measurement value is presented. Every 10
minutes, a measurement value is written into the data memory. If you switch
to another display and then return to the graphic display, the recorded data
is read from the data memory and is presented. Due to the data recording in
intervals of 10 minutes, the curve is smoothed.
For periods during which no measurement values are available (e.g. device
is turned off, no sensor is connected), the measurement value progress
curve is hatched.
The info line is presented like in the two other online display modes.