PARTS OF THE LOCK BOX
Parts of the Safe
A. Key Entry
B. Indicator Light
C. Fingerprint Scanner
D. Wake Up Button
E. Initialization Button
F. Battery Compartment
and Cover
G. Cable Slot
H. Mounting Holes
(located under the safe)
See reverse side for more information
A
B
C
D
F
G
E
9/14
BC346
H
OPENING THE LOCK BOX WITH ACCESS KEY
1. Insert access key into key entry, turn clockwise to open,
partially lift lid of lock box and remove access key by turning it
counter clockwise
2. Open lock box by lifting the lid of the lock box
NOTE
Store access keys in a secure place. NOT inside of lock box
When calling for replacement or additional access keys have
the access key code number ready. The access key code is
etched in the key entry and on the access keys.
BATTERIES
1. Locate the battery compartment and remove battery cover
2. Gently slide battery holder out of the compartment
3. Place 4, AA batteries and pay attention to the polarity of
each battery
4. Gently slide battery holder back into place
5. Replace battery cover
REPLACING BATTERIES
The red indicator light will start flashing and a continuous
beeping sound will be heard. This indicates that the batteries
are low.
1. Open lock box by using the access key; turn clockwise
2. Repeat steps 1-5 of “Batteries” and replace old batteries with
new batteries
3. Close lock box and ensure that the lock box is locked
NOTE
After replacing the batteries lock box retains registered fingerprints
REGISTERING A FINGERPRINT
The lock box is in demo mode, ANY fingerprint can open the lock box
1. With the lock box open press and release the initialization button
2. A beep will be heard and scanner will flash red
3. Immediately place desired finger on the scanner
- Hold finger still, until registration process is complete
4. Registration process is complete when a total three beeps
are heard. See below
Successful Save
- Indicator light will flash green, followed by one beep,
indicator light will flash green twice and two
consecutive beeps
- Registration has been successful
Unsuccessful Save
- Indicator light will flash green, followed by one beep,
indicator light will flash red and two consecutive beeps
- Repeat registration process again
NOTE
- To add more fingerprints/users repeat steps above
- Stores up to 120 fingerprints
- For security purposes wipe fingerprint off scanner
For Accurate and Consistent Fingerprint Scanning
- Use scanner in low light conditions
- Use the index finger
- Place and hold finger firmly on the scanner
- Each user should register 2-3 different fingerprints
TESTING A REGISTERING A FINGERPRINT
1. With lock box lid open, press the wake up button
2. Place registered finger on the scanner
Successfully Saved Fingerprint
- Indicator light will flash green indicating a valid fingerprint
- You will hear the lock box unlock
Unsuccessful Fingerprint
- Indicator light will flash red and green consecutively
indicating that the fingerprint in not valid
- Repeat steps in “Registering A Fingerprint”
4. Close lock box and ensure that the lock box is locked
5. For security purposes wipe fingerprint off scanner
OPENING THE LOCK BOX USING A FINGERPRINT
1. Press the wake up button
2. Place registered finger on the scanner
3. The indicator light will flash green indicating a valid fingerprint
4. Gently lift the door of the lock box
5. Close lock box and ensure that the safe is locked
6. For security purposes wipe fingerprint off scanner
DELETING ALL FINGERPRINTS
1. With the lock box open locate the battery compartment and
remove battery cover
2. Gently slide battery holder of out of the compartment
3. Remove all 4, AA batteries from battery holder
4. Press wake up button a few times to release remaining
electronic power
5. Re-insert 3, AA batteries and pay attention to the polarity of
each battery
6. Press and hold down the initialization button
7. Re-insert the last AA battery you will hear 2 beeps, release
initialization button
8. Gently slide battery holder back into place and replace
battery cover
WARNING
Avoid leaving lock box open and unattended; it will allow
unauthorized individuals to add their fingerprint and/or
reprogram the lock box, gaining full access to the lock box
and the contents.
User Manual For Portable
Biometric Compact Lock Box
