Barry-Wehmiller BW Integrated Systems Streamfeeder V-1400IJ, Руководство пользователя

Страница: 31 / 57

24
V-1400IJ M
anual
Preventive Care
Cleaning Feed and Discharge Belts
To clean feed belts:
1. Turn Off feeder and remove power cord from outlet.
2. Apply a small amount of isopropyl alcohol to a soft cloth.
3. Use your hand to move the feed belt, starting with one feed
belt at a time and carefully pressing the moistened area of the
cloth to the belt. As you rotate the belt, use moderate pres -
sure to wipe across the belt, making sure to wipe in direction
of grooves. After several rotations of the belt, repeat for each
belt.
4. Using a dry cloth, go back to the first feed belt cleaned and
use moderate pressure against the belt for several revolutions
to ensure the belt is dried. Repeat for each belt.
5. Restore power.
Use only isopropyl alcohol. Other solvents
can cause belts to wear prematurely, and even
cause total breakdown of material.
Cleaning schedule for various materials:
• Typical: every month
• Dusty: after every shift
• High ink or varnish: 1 time per shift
or as needed to maintain coefficient of
friction integrity
Cleaning schedule for various products:
• Typical: every month
• Dusty: after every shift
• High ink or varnish: 1 time per shift
Cleaning Gate Assembly
Use only isopropyl alcohol (98% concentration). Do not use any
other types of solvents. They can cause premature wear of the
belts, or even total breakdown of the o-ring.
To clean gate assemblies:
1. Turn Off feeder and remove power cord from outlet.
2. Remove
gate assembly from bracket assembly.
3. Apply a small amount of isopropyl alcohol to a soft cloth.
4. Wipe across O-rings, or angled wedge if applicable. First wipe
in one direction, then the other.
5. Using a dry cloth, go back and wipe all surfaces to ensure they
are dried.
6. Reinstall gate assembly and restore power. It may be neces-
sary to re-check alignment of feeder with host machine if
feeder was moved from original installation position (for a
review, refer back to “Installing the Machine”).
Depending on the application, it may be
necessary to move the feeder from original
installation so as to access the gate assembly.