Barry-Wehmiller BW Integrated Systems Streamfeeder V-1400IJ, Руководство пользователя

Страница: 25 / 57

18
V-1400IJ M
anual
STEP 5:
Running Test Cycles
For vacuum base applications:
1. With the feeder already fully loaded and powered On, run the
vacuum base through several cycles.
2. Notice transition of product from feeder gate assembly area to
the transfer area of the vacuum base. Adjust feeder horizon -
tally as needed (refer to “Installing the Machine”).
3. Adjust feeder speed as needed to coincide with transport belt
speed.
It might be helpful to know that a properly set
gap will allow the leading edge of product to
enter at about the center line of the cylinder, as
the previous or bottom piece is exiting the gate
assembly area.
STEP 4:
Setting/Adjusting Speed
1. Set the variable speed control to the lowest speed (counter-
clockwise).
Feeder motor stops if turned completely counter-
clockwise.
2. Start by slowly turning the control clockwise to gradually in -
crease feeder speed to coincide with the production line speed
of your particular application.
Turn the feeder power On by pushing the horizontal line ( — ) at the
Power
On/Off rocker switch.
• For feeders using extenal run, feeder motor will not run
until the entire base power switch is turned On (feeder On/
Off is controlled via run enable input cable).
STEP 3:
Powering On Feeder
Make sure:
• Leading edge of bottom product stops at proper location.
• Proper separation is occurring at gate assembly area.
• Product is not skewing.
• Effective preshingling is occurring at curvature of gate assembly.
• Product is not being damaged during cycling.
• Feeder is secured and will not move during operation.
STEP 6:
Final Check